D&R AXUM Manuel d'utilisateur télécharger pdf (Page 16)

Triple Dig Input Module

Airlab from D&R Phone +31 294 418014, email: [email protected] Page 16

5 TRIPLE DIG INPUT MODULE

MONO

Every channel has a mono switch with LED to send a mono input signal to both outputs of

the module.

(PHANTOM POWER, not on the front panel. But 48 volt switch able by a jumper setting (see also

chapter 12))

MIC-TRIM

The trim control adds an extra 13dB of mic gain to the mic pre-amp. An optimum gain

range can be accomplished in this way.

GAIN

The gain control adjusts the incoming signal level on the MIC and DIG-LINE inputs.

LINE A

The triple-dig module default is in 'LINE A' mode (AES3). If no AES3 signal is connected

or the AES3 signal can’t be read, the LED will be red-flashing. Operating the 'DIG-LINE

B' switch or the MIC switch changes its mode.

LINE B

When ‘LINE B’ is selected (S/P-dif) the green LED is illuminated. If no S/P-dif signal is

connected or the S/P-dif signal can’t be read, the LED will be red-flashing.

MIC

MIC input selector switch between MIC-input or Line-A/B input. When the LED is illuminated

the MIC-input is activated.

HIGH

Adjusts high frequencies with +/- 12 dB at 10 kHz shelve.

MID

Adjusts mid frequencies with +/- 12 dB at 1 kHz bell.

LOW

Adjusts the low frequencies with +/- 12 dB at 60 Hz bell.

SUB

The sub switch assigns the signal in stereo to the sub output.

PROG(RAM)

The program switch assigns the signal in stereo to the program output.

STEREO AUX

Transmits a stereo signal to the AUX master post fader. A jumper on the board determines

whether this is pre or post VCA.

The channel 'ON' switch also affects the aux send (only when set to post fader).

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 114 115

Pas de commentaire

D&R AXUM Manuel d'utilisateur Page 16