D&R AXUM Manuel d'utilisateur télécharger pdf (Page 29)

Master Section

Airlab from D&R Phone +31 294 418014, email: [email protected] Page 29

8 MASTER SECTION

TAPE SEND

This section of the master houses

the switches and controlling what's

going to the tape outputs.

A selection can be made between

three outputs of the Airlab. With all

switches up the main program

signal is recorded. As soon as one

of the other switches is pressed,

the corresponding FROM SUB or

FROM AUX. output signals are

recorded.

NOTE: With this circuitry it is

possible to record stereo

sources from the channels

assigned to the sub buss during

broadcast.

AUX OUT STEREO

This is a stereo output of the AUX

masters. The level is +6dBu.

The corresponding talk back switch

sends the talk back signal to both

outputs.

NOTE: Overall level of Aux.

outputs also affects the talk back level for these outputs only.

CRM

The CRM is normally following the Program output unless one of the input bank switches is active.

EXT(ERN)

This stereo input can be used for any stereo source that needs to be monitored in the CRM outputs. The

input level is set to be 0dBu.

AUX

This input source switch lets you listen to the stereo Aux. outputs.

(FROM) AIR

This is the input select for the CRM/phones output. Either the program mix is heard in the CRM/phones or

the 'from air' signal.

Figure 2: The Master Section

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 114 115

Pas de commentaire

D&R AXUM Manuel d'utilisateur Page 29