D&R AXUM Manuel d'utilisateur télécharger pdf (Page 88)

A·X·U·M User Manual Version 2.5 - 2011-01-28

AXUM from D&R - Phone: +31 294 418014 - E-Mail: info@d-r.nl - 88 -

16 Product Safety

This product is been manufactured with the highest standards and is double-checked in our quality

control department for reliability in the "HIGH VOLTAGE" section.

• Never remove any panels, or open this equipment.

CAUTION

• No user serviceable parts inside.

• Equipment power supply must be grounded at all times.

• Only use this product as described, in user manual or brochure.

• Do not operate this equipment in high humidity or expose it to water or other liquids.

• Check the AC power supply cable to assure secure contact.

• Have your equipment checked yearly by a qualified dealer service center.

• Hazardous electrical shock can be avoided by carefully following the above rules.

Voltage and current cause an electrical shock. In practice the higher the voltage the higher the

current will be and the higher the shock. However, there is another thing to consider and that is

resistance. When the resistance in Ohms is high between two poles, the current will be low and

visa versa. All three of these; voltage, current and resistance are important in determining the

effect of an electrical shock.

PLEASE READ THE FOLLOWING INFORMATION VERY CAREFULLY

The severity of a shock is caused by the amount of current flowing through a person.

A person can feel a shock because the muscles in a body respond to electric current. Current

can also be fatal when it causes the chest muscles to contract and stop breathing.

At what potential is current dangerous? Well the first feeling of current is a tingle at 0.001 Amp

of current. The current between 0.1 Amp and 0.2 Amp is fatal.

Imagine that your home fuses of 16 Amp can handle 200 times more current than is necessary

to kill. How does resistance affect the shock a person feels? A typical resistance between your

two hands "dry" condition could be well over 100,000 Ohm. But if your body is transpiring

extensively your body resistance is lowered by more than 50%. This is a situation in which

current can easily flow.

Always earth all your equipment by the grounding pin in your main plug. Proper wiring and

isolation input/output transformers should only cure hum loops.

Always replace fuses with the same type and rating after the equipment has been turned off

and unplugged. If the fuse blows again you have an equipment failure. Do not use it again and

return it to your dealer for repair.

And last but not least be careful not to touch a person being shocked as you, yourself could

also be shocked. Once removed from the shock, have someone send for medical help

immediately!

Always keep the above-mentioned information in

mind when using electrically powered equipment.

1 2 ... 83 84 85 86 87 88 89 90 91 92 93 ... 120 121

Pas de commentaire

D&R AXUM Manuel d'utilisateur Page 88